OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DD2

Hybrid/EV Battery Cell Balancing Circuit J Stuck Off

P0DD2 marks circuit J as unable to bleed: balancing is commanded, but the six cells of group J keep their charge. Ford lists the code in its 2015 hybrid OBD summary with the same power-up test as for the stuck-on case, run for 100 ms with the contactors still open, two consecutive power cycles and the 75 mV limit against the average cell voltage. GM's 2013 eAssist table documents a more direct test under its own code P1EAA: with the key off and the contactors open, a cell's balancing resistor is switched on and the cell voltage has to move by at least 0.1 V; two failed samples across key cycles give a Type A fault. Over many charges group J ends up high and caps the full charge. Opposite: P0DD1.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / D2

Possible causes

  • Bleed resistor of circuit J open or burnt high
  • Balancing switch of group J no longer closing medium
  • Interrupted balancing lead between cell tap and board low

Symptoms

  • Check engine light without noticeable change in driving
  • Cells of group J at the top of the cell list at the end of charging
  • Usable battery capacity declining over time

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DD2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication