P0DD1
Hybrid/EV Battery Cell Balancing Circuit J Stuck On
P0DD1: group J's bleed path keeps drawing current after balancing should have ended. Ford's 2014 OBD summary for its hybrids and plug-ins assigns the code to the BECM, which checks at power-up, before the contactors close, for 100 ms: if one of the six cells in the circuit sits more than 75 mV away from the mean of all cells, and this repeats on two consecutive power cycles, the fault is stored. Ford's 2014 code list marks it as a MIL code. Designers guard against this failure: LaunchPoint patent US8598840B2 lets current flow through a bleed resistor only with an encoded, redundant enable that a timer cancels if it is not withdrawn. Group J will sag during standstill. Opposite case: P0DD2.
Possible causes
- Balancing transistor of group J shorted and conducting permanently high
- Balancing enable for channel J not withdrawn by the monitoring electronics medium
- Cell in group J with high self-discharge producing the same voltage pattern low
Symptoms
- Check engine light and hybrid battery warning after switching on
- Group J clearly lower than the rest after parking
- Shorter electric range
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DD1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.