P0DCC
Hybrid/EV Battery Cell Balancing Circuit I
P0DCC concerns the hardware of balancing circuit I, the ninth group, so only packs split into at least nine balancing channels can raise it. No maker publishes this exact code: Ford's hybrid summaries assign letter I only to the stuck codes P0DCD and P0DCE, and Audi's A3 e-tron bulletin stops at H. How an electrical fault of such a channel can be caught is shown in Renesas patent US9735567B2: a pull-up resistor lifts the balancing terminal to cell potential when the switch fails to close, so commanding it on and still seeing the full cell voltage exposes an open path. Broken leads, corroded connectors or a faulty monitoring chip are the usual suspects. California's regulation demands monitoring of such parts on hybrids. Related: P0DCD to P0DCF.
Possible causes
- Broken balancing or sense lead of group I high
- Corroded connector between cell group I and its monitoring board medium
- Defective monitoring chip for channel I low
Symptoms
- Hybrid battery warning with check engine light
- Electric drive or charging limited by the battery controller
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DCC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.