OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DC9

Hybrid/EV Battery Cell Balancing Circuit H Stuck On

P0DC9: the bleed path of group H keeps conducting. Ford lists the code for its 2016 hybrid and plug-in BECM, judged at start-up from the cell spread within the six-cell circuit. Besides draining charge, a switch that cannot open turns energy into heat around the clock. Monitoring chips are built to limit that heat: TI's BQ79616-Q1 pauses all balancing when sensors next to its internal bleed FETs exceed about 105 °C, or when a thermistor near the external resistors passes a set limit. A shorted FET ignores such a pause, so the hot spot persists. Expect group H to sit low after standstill. The CARB rule permits judging balancing by switch response. Circuit fault: P0DC8, inactive case: P0DCA.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / C9

Possible causes

  • Bleed FET of group H shorted and unaffected by thermal pause high
  • Heat damage on the monitoring board around the bleed resistors of H medium
  • Chip logic keeping the balancing enable of channel H active low

Symptoms

  • Check engine light and hybrid battery warning
  • Group H noticeably lower than the rest after parking
  • Locally raised temperature reading in the battery module

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DC9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication