OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DC6

Hybrid/EV Battery Cell Balancing Circuit G Stuck Off

P0DC6 is set when circuit G stays idle although balancing is requested, so group G cannot give up charge. Ford names the code in its 2015 hybrid OBD summary and decides it from the start-up voltage comparison of the six cells per circuit. Ford's own patent application US20130030617A1 shows why this matters during charging: a resistor placed across a nearly full cell routes some of the charging current past it, or the higher cells are bled down at the end and the pack is topped up again. With circuit G dead, neither route works, and the cells of G define when charging must stop. The driver sees a slowly shrinking electric range, not a breakdown. Detecting it is a CARB requirement for hybrids. Opposite: P0DC5.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / C6

Possible causes

  • Shunt resistor of group G open, no current can bypass the cells high
  • Balancing switch of group G does not close on command medium
  • Pin backed out of the cell harness connector low

Symptoms

  • Electric range shrinks gradually over weeks
  • Charging stops before the indicated target
  • Check engine light without immediate drivability change

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DC6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication