P0DC4
Hybrid/EV Battery Cell Balancing Circuit G
P0DC4 points to the hardware path of balancing circuit G: lead, switch, resistor or the chip that drives them. On the 2016 Audi A3 e-tron it appears as P0DC400 in bulletin 93 17 04, never alone but in a row with the circuit codes of groups A to H. When so many channels fail at once, a shared cause is far more likely than eight broken circuits; Audi blamed late CAN start-up and fixed it with software for J840 and JX1. A genuine defect looks different: Texas Instruments describes for its BQ79616-Q1 monitor a test that turns the bleed FET on and expects the voltage across it to fall below half the cell voltage; a channel that fails this is singled out. Supervision of these parts is mandated in CARB's OBD regulation, 13 CCR 1968.2. Siblings: P0DC5 to P0DC7.
Possible causes
- Common software or communication cause when circuit codes A to H appear together (Audi A3 e-tron) high
- Bleed FET of channel G failing the on-state check medium
- Corroded or loose connector on the cell harness of group G low
Symptoms
- Hybrid battery warning with check engine light
- External charging refused now and then
- Scan tool lists several circuit codes plus a control module fault
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DC4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.