OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DC1

Hybrid/EV Battery Cell Balancing Circuit F Stuck On

P0DC1 says that the bleed path of cell group F appears to stay engaged. Ford lists it for the BECM of its full and plug-in hybrids in the OBD system summaries of model years 2014 to 2019. The battery there is split into fourteen balancing circuits, A to N, each looking after six cells. The check runs for 100 ms at every power-up while the main contactors are still open, so no load current blurs the readings: if any of the six cells in a circuit strays more than 75 mV from the mean of all cell voltages (in the 2019 summary for 0.1 s), the circuit is judged stuck. A group drained by a closed switch during standstill shows up exactly this way. Paragraph (e)(15.2.3) of the CARB regulation explicitly allows such switch-response monitoring. Opposite case: P0DC2.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / C1

Possible causes

  • Bleed transistor of group F shorted, so the resistor stays connected high
  • Monitoring chip output keeps the switch of circuit F enabled medium
  • A cell of group F with high self-discharge mimicking a drained group low

Symptoms

  • Check engine light with hybrid battery warning after a cold start
  • Cells of group F clearly below the pack average after standstill
  • Reduced electric range or assistance

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DC1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication