P0DC0
Hybrid/EV Battery Cell Balancing Circuit F
P0DC0 marks an electrical fault in balancing circuit F, the sixth cell group whose bleed path the battery controller can switch. Audi lists P0DC000 for the 2016 A3 e-tron in bulletin 93 17 04 (2046556/1), together with the circuit codes for groups A to H and B200000. Owners noticed that charging failed now and then or that the car claimed a charger was plugged in when none was. Audi traced this to software that started CAN communication too late; reflashing the high voltage battery controller J840 (address 008C) and the power electronics JX1 (00C6) cured it. On this car the entry therefore describes a timing problem rather than burnt parts. California's OBD rule (13 CCR 1968.2) obliges hybrids to supervise balancing. Stuck states and implausible results of group F use P0DC1 to P0DC3.
Possible causes
- Battery controller software that starts CAN communication too late (Audi A3 e-tron, J840/JX1 update) high
- Open or chafed balancing/sense lead of cell group F medium
- Defective cell monitoring chip serving group F low
Symptoms
- Charging fails intermittently
- Cluster shows a connected charger although no cable is plugged in
- Several balancing circuit codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DC0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.