P0DB1
Hybrid/EV Battery Cell Balancing Circuit B Stuck On
P0DB1: in circuit B the bleed path stays closed even after the controller withdrew the command. The cells of group B are drained without pause, so their voltage falls behind the others, worst during long standstill. Detection usually compares commanded and reported switch state; GM's eAssist logic for a related code needs 7 failed of 10 samples before a Type B entry. Toshiba describes a comparator check that spots a shorted balancing switch while it should be off. Ford names P0DB1 for its hybrid BECM; the 2015 OBD summary flags it when, at start-up with open contactors, one of the six cells served by circuit B differs from the pack mean by more than 75 mV. The electrical fault of the same circuit is P0DB0, the opposite stuck state P0DB2.
Possible causes
- Shorted balancing transistor in circuit B high
- Drive output of the monitoring chip stuck active medium
- Moisture or contamination on the module board creating a leakage path low
Symptoms
- MIL with battery warning
- Group B cells clearly low after parking
- Usable charge and range shrinking
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DB1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.