OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DAC

Hybrid/EV Battery Cell Balancing Circuit A

P0DAC reports an electrical fault in balancing circuit A, meaning the wiring, switch or monitoring chip behind it, not a balancing result. Audi uses it on the e-tron GT (2022-2026) in battery management address 008C and spells it out as an electrical fault of cell controller 1. Bulletin 2074056 explains that a short power interruption while the 12 V battery is reconnected can log this entry; the guided fault finding then proposes new HV modules, which Audi calls unnecessary and resets remotely. A later reporting case (2078729) pairs P0DAC00 with the red onboard supply lamp and a car that will not start. Audi already listed P0DAC00 for the 2016 A3 e-tron (bulletin 2046556), where new software cured it. Stuck states and implausible results are P0DAD to P0DAF.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / AC

Possible causes

  • Brief 12 V supply interruption, e.g. while reconnecting the 12 V battery (Audi e-tron GT) high
  • Defective cell monitoring controller or balancing switch of circuit A medium
  • Loose or corroded sense/balancing lead connector at the module medium

Symptoms

  • Battery management warning or red onboard supply lamp
  • Vehicle may refuse to start or enter drive readiness
  • Diagnostic tester proposes replacing HV battery modules

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DAC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication