OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DAA

Battery Charging System Isolation Fault

P0DAA reports that the resistance between the charging-side HV bus and chassis ground has fallen too low, so the charging path or the battery is no longer safely insulated. GM documents the logic for the 2014 Chevrolet Volt and Cadillac ELR in the HPC2 (VICM): in charge-only mode the active isolation resistance is measured, at most once per wake-up; below 325 kOhm, or 400 kOhm while the code is active, for 10 s, and with five of the last ten results low, the code sets as Type A with MIL after one trip. GM preliminary information PIC5920 links it to vehicles that will not charge and points to coolant leaking into the battery pack or insulation loss in the cells; technicians check the pack drain plug and reprogram HPCM2 and BECM, and call support if isolation stays under 275 kOhm. GM used P0AA6 for this on 2011–13 Volts.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / AA

Possible causes

  • Coolant leaking into the battery pack (GM) high
  • Insulation loss within battery cells or sections (GM) medium
  • Outdated HPCM2/BECM calibration (GM, 2011–2014) medium
  • Damaged insulation in the on-board charger or charging cables low

Symptoms

  • Vehicle will not charge
  • MIL on (GM Type A)
  • Low coolant level in the battery coolant reservoir

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DAA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication