P0DA8
Hybrid/EV Battery Voltage/Drive Motor A Inverter Voltage Correlation
P0DA8 compares the traction battery voltage with the voltage measured at the inverter of drive motor A; both should match closely once the contactors are closed. Denso cites earlier diagnostics that blame a voltage sensor when the two differ by more than a set amount (US9819293B2). Honda describes it as a voltage fault of its MPI inverter module: recall 15-057 for the 2014–15 Accord Hybrid ties it to the battery cell voltage sensor misreading inverter noise, with an electric-only emergency mode capped near 40 mph, and was a vehicle emissions recall in California. Warranty extensions 20-030 and 20-021 for Civic Hybrid 2012–15 and ILX Hybrid 2013 list it among codes from a cracked solder joint in the inverter, which is replaced. Ford logs P0DA8 on 2021–22 Mach-E with a flat 12 V battery and replaces the HV junction box.
Possible causes
- Cracked solder joint in the motor power inverter (Honda Civic/ILX Hybrid) high
- Battery cell voltage sensor software misreading inverter noise (Honda Accord Hybrid recall) medium
- High-voltage battery junction box faulty (Ford Mach-E) medium
- Battery-side or inverter-side voltage sensor drifting low
Symptoms
- MIL and hybrid system warning
- Fail-safe electric mode with strongly limited speed (Honda)
- Discharged 12 V battery (Ford Mach-E)
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DA8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.