OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DA5

Drive Motor B Inverter Voltage Sensor A Circuit Low

P0DA5 reports that the rear inverter voltage signal sits at the bottom of its range, the classic result of an open circuit, a short to ground or no high voltage arriving at all. Mitsubishi sets it in the rear motor control unit of the 2018 Outlander PHEV when, with the propulsion system active, the sensor output stays below 0.5 V, roughly 10 V on the bus, for 0.3 s. If the front unit and the generator unit report undervoltage too (P1A1B, P104D), the manual inspects the high-voltage fuse, cabling, battery section voltages and bus bars; otherwise it checks the torque of the rear battery cable at both ends before replacing the rear unit. A loose cable can therefore mimic a sensor fault. The 2023 model lists the code as a minimum range check with MIL. The high side is P0DA6.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / A5

Possible causes

  • Rear high-voltage battery cable (P and N lines) loose or damaged medium
  • High-voltage fuse not seated or loose bus bar in the battery medium
  • Sensing circuit in the rear motor control unit failed medium
  • Fault inside the traction battery pack low

Symptoms

  • MIL and plug-in hybrid warning on
  • Rear motor drive switched off
  • Possible no-READY condition if other units also lose voltage

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DA5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication