P0DA4
Drive Motor B Inverter Voltage Sensor A Circuit Range/Performance
P0DA4 flags a rear inverter voltage that is electrically valid but disagrees with the other voltage readings on the same high-voltage bus. Mitsubishi spells out the check for the 2023 Outlander PHEV: once the power drive unit has at least 8 V, voltage control is off, CAN is healthy and the rear value is available, all three comparisons must fail together, namely capacitor 2 main, capacitor 2 sub and capacitor 1 each differing from the rear inverter reading by at least 100 V, held 0.2 s or longer. Because a single deviating reading is not enough, the rear sensor itself is the prime suspect. The manual first clears higher-priority codes and the rear unit's P0C7A, P0DA5, P0DA6 and P30D1, then replaces the power drive unit. The warning light and MIL come on. The battery-side correlation code is P0DA9.
Possible causes
- Rear inverter voltage sensing drifts against the other bus readings high
- Power drive unit faulty (Mitsubishi final repair step) medium
- Underlying fault in the rear motor control unit (P0C7A, P0DA5, P0DA6, P30D1) medium
- Battery management unit reporting incorrectly low
Symptoms
- Plug-in hybrid system warning and MIL on
- Rear motor power limited
- Code returns only after the OBD-II drive cycle
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0DA4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.