OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DA3

Drive Motor B Inverter Voltage Sensor A Circuit

The inverter of drive motor B, usually the rear electric motor in all-wheel-drive hybrids, measures its own DC link voltage; sensor A delivers that value to the motor controller. P0DA3 is the general circuit fault for this channel, with no finer verdict such as low or high. No manufacturer documents P0DA3 publicly. Mitsubishi watches the same sensor in the rear motor unit of the Outlander PHEV but reports it with the specific codes P0DA5 and P0DA6, whose diagnosis starts with the high-voltage fuse, cabling and battery terminals before the motor control unit is replaced. Denso describes in patent US9819293B2 how the input voltage reading of an inverter is judged against a battery reading or an estimate from the control loop. Without a valid voltage the rear drive is usually limited or switched off. Specific faults are P0DA4 to P0DA7.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / A3

Possible causes

  • Voltage sensing circuit inside the rear motor control unit defective medium
  • Loose high-voltage cable or terminal at the rear inverter medium
  • Low-voltage connector or harness to the inverter controller faulty medium
  • High-voltage fuse loose or blown low

Symptoms

  • Hybrid system warning and MIL
  • Rear electric drive reduced or unavailable
  • Reduced power or no READY state

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0DA3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication