OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DA1

Battery Charger A Coupler Lock Position Sensor Circuit High

P0DA1 is the high-side fault of the lock position feedback: the signal stays near its upper limit, which points to an open circuit somewhere in the sensor loop rather than a grounded wire. In the 2023 Outlander PHEV, Mitsubishi sets it in the PHEV-ECU when the supply is on and a high input from the lock position reading is seen. The test steps reveal the likely weak spots: terminal 1 of the lock actuator connector must have a ground path of no more than 2 Ω, terminal 2 must show battery voltage, the signal line to the PHEV-ECU must be intact, and the sensor in the inlet harness must read 16.8 kΩ within 5 percent. A failed ground, a broken wire or an open sensor therefore all end here. Mitsubishi's warning lamp table does not list it. The low counterpart is P0DA0.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / A1

Possible causes

  • Ground connection of the lock actuator connector interrupted high
  • Open signal line between inlet harness and PHEV-ECU medium
  • Position sensor in the inlet harness open or far above 16.8 kOhm medium
  • PHEV-ECU input defective low

Symptoms

  • Charging plug lock not confirmed, DC charging refused
  • Charging system message, no MIL documented

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0DA1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication