OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0DA0

Battery Charger A Coupler Lock Position Sensor Circuit Low

P0DA0 means the lock position feedback sits at the bottom of its range, typically from a signal wire shorted to ground. Mitsubishi documents it for the 2023 Outlander PHEV: with the IGCT supply on, the PHEV-ECU detects a low input from the lock position reading. The sensor sits in the charge connector lock actuator, part of the inlet harness; the signal line should carry battery voltage at the unplugged connector, and the sensor should measure 16.8 kΩ, give or take 0.84 kΩ. Depending on the result, technicians repair the line, replace the inlet harness or replace the PHEV-ECU. Ford names P0DA0:00 in TSBs 22-2355 and 23-2014 for its 2021 to 2023 electric models, alongside P0D9E, after a broken lock pin; there only the actuator is replaced. The opposite fault is P0DA1.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / A0

Possible causes

  • Lock position signal line shorted to ground (Mitsubishi) high
  • Actuator pin broken after the plug was pulled while latched (Ford) medium
  • Position sensor in the inlet harness outside its resistance specification medium
  • PHEV-ECU input defective low

Symptoms

  • DC fast charging not possible
  • Charger Service Required message (Ford)
  • Plug is not latched or charging ends right after start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0DA0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication