P0D9D
Battery Charger Coupler Temperature Sensor A Circuit Intermittent/Erratic
P0D9D is logged when the signal of temperature sensor A in the charging inlet jumps or drops out for short moments instead of failing for good. The sensor sits beside the power pins so the car can cut back or end charging once contact resistance heats them; TE Connectivity patents US10960781B2 and US11117478B2 name thermistors and resistance thermometers for this job. No manufacturer documents P0D9D publicly. A related smart case shows the pattern: with the 22 kW charger, Mercedes blamed inlet sensor codes on loose low-voltage plugs at the charger and warned that the fault may only show up with warm or cold parts. Typical is a session that stops for no clear reason and works again later. Steady circuit, plausibility, low and high faults are P0D99 to P0D9C.
Possible causes
- Sensor wiring between inlet and charger with a loose or chafed contact high
- Low-voltage connector at the on-board charger not fully seated (seen on smart for sibling codes) medium
- Moisture or corrosion in the inlet harness connector medium
- Temperature element in the inlet with an internal intermittent break low
Symptoms
- Charging stops now and then and resumes on a later attempt
- Charging power reduced for a while without an obvious reason
- Charging fault message that comes and goes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D9D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.