OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D97

Battery Charger Coupler Unlock Control Circuit High

P0D97 reports that the unlock control output sits higher than it should while the module is not driving it, or does not follow the command, which points to a release line touching a supply voltage. Such a fault is critical for safety logic: a release path that may be energised unintentionally could free the plug during current flow, so control units typically end the charging session or refuse to begin it while the code is active. No manufacturer documents P0D97 openly. CARB's comprehensive-component rules require output circuits to be checked for shorts and correct response, and the TE Connectivity actuator patent EP3252879B1 stresses that the lock position must be reliably detected to prevent unsecured charging. P0D96 is the short to ground, P0D93 the matching fault on the locking side.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 97

Possible causes

  • Unlock drive wire shorted to a supply wire in the harness high
  • Internal short inside the lock actuator medium
  • Unlock driver stage of the module stuck on low

Symptoms

  • Charging session stops or does not start
  • Plug is not held firmly in the inlet
  • Charging system fault message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D97

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication