OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D96

Battery Charger Coupler Unlock Control Circuit Low

P0D96 indicates that the voltage on the unlock control output is too low, which usually means the release line is shorted to ground or the actuator pulls an overcurrent as soon as it is energised in the release direction. To protect its driver, the module stops commanding, so the pin stays where it is. If it was latched, the plug remains captive until the emergency release is used; if it was already open, the car may refuse the next session because it can no longer trust the lock. No manufacturer publishes this code, so the explanation draws on CARB's monitoring logic for output components and on actuator patents in which a position sensor confirms each end stop (GM, US8936482B2). Compared with P0D95 the circuit is not broken but shorted; the opposite fault, a short to supply, is P0D97.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 96

Possible causes

  • Unlock drive wire shorted to ground at a chafe point high
  • Actuator seized, for example by ice or dirt, causing overcurrent medium
  • Moisture in the actuator connector medium
  • Unlock driver stage of the module defective low

Symptoms

  • Charge plug cannot be unplugged after charging
  • Emergency release needed to free the cable
  • Next charging session refused

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D96

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication