P0D95
Battery Charger Coupler Unlock Control Circuit/Open
P0D95 concerns the release direction: the output that withdraws the locking pin shows an open circuit when the module commands unlock. Because J2012 assigns lock and unlock separate control circuits, the module watches each drive direction on its own, and a break can disable only the release. That is the more awkward failure, since the cable may stay latched in the inlet after charging; inlets therefore carry a mechanical emergency release, which Audi's Q4 e-tron bulletins mention as the fallback when the plug will not come out. No manufacturer documents P0D95 publicly; it rests on CARB's rule that output components be checked for circuit faults and proper response to commands, and on lock actuator patents such as GM's geared-motor design (US9279276B2). The shorted variants are P0D96/P0D97, the locking side P0D91–P0D94.
Possible causes
- Open unlock drive wire or loose pin in the actuator connector high
- Motor winding or internal contact of the actuator open medium
- Corrosion in the connector at the inlet from road splash medium
- Unlock driver stage of the controlling module defective low
Symptoms
- Charge cable stays locked in the inlet after charging
- Plug can only be freed with the emergency release
- Charging system fault message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D95
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.