OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D92

Battery Charger Coupler Lock Control Circuit Low

P0D92 says the voltage on the lock control output stays too low, typically because the drive line is shorted to ground or the actuator draws far too much current, so the module cannot energise the latch properly and shuts its driver off. No manufacturer publishes this exact code. The hardware it supervises is described in patents: a small geared DC motor pushes a pin or cam across the plug latch (GM, US9279276B2), and a position sensor reports whether the pin really reached the locked end, otherwise fast charging is withheld (GM, US8936482B2). Which module drives the lock differs by maker (on-board charger at the VW group, drivetrain unit at Mercedes, SOBDM at Ford). The open-circuit case is P0D91, a short to supply P0D93; for the driver, the charging session simply never starts.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 92

Possible causes

  • Lock drive wire chafed and shorted to body ground high
  • Actuator jammed or binding, drawing excessive current medium
  • Water in the actuator connector at the inlet medium
  • Driver output of the controlling module defective low

Symptoms

  • Charging session does not start after plugging in
  • Charge plug is not held in the inlet
  • Charging fault message in the cluster or app

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D92

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication