P0D91
Battery Charger Coupler Lock Control Circuit/Open
P0D91 means the module that drives the charge-plug latch sees its lock output as electrically open: when it commands the latch closed, no current flows through the wiring and actuator winding. Without a confirmed lock, the car normally refuses to start a charging session, because the plug could be withdrawn under load. Mercedes-Benz documents P0D9100 in the drivetrain control unit (PTCU, N127) of its recent P3 plug-in hybrids such as the S 580 e and the AMG GT 63 S E and C 63 S E: bulletin LI47.70-P-078127 describes a car that will not charge on AC with the check engine light on and names hardware or software as possible causes still under investigation. Shorts on this output are P0D92/P0D93, a driven but ineffective lock is P0D94, and the release side has P0D95–P0D98.
Possible causes
- Connector at the lock actuator loose, corroded or backed out high
- Broken wire in the harness between control unit and inlet medium
- Motor winding inside the lock actuator burnt through medium
- Driver stage or software of the controlling module (Mercedes names both) low
Symptoms
- Vehicle does not charge on AC
- Check engine light on (Mercedes)
- Charging system warning in the instrument cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D91
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.