P0D88
Battery Charger Coupler Status Indicator Control Circuit A High
P0D88 is stored when channel A of the charge port status indicator sits at a high level although the driver is holding it off, typically because the line touches a voltage-carrying wire or the driver stage leaks. The fault is therefore seen in the switched-off state; GM's Volt evaluated its own charge-status LED (P0D2C) for short to battery only while the LED was meant to be dark. No manufacturer documents P0D88 publicly. The visible result is often the reverse of P0D87: channel A glows constantly or faintly, so the port may suggest a charging state that does not exist. A pinched harness at the flap hinge, a bridged connector or a defective output in the control module are the causes to check. Charging works normally; P0D86 and P0D87 cover open and grounded faults of the same channel.
Possible causes
- Channel A wire shorted to a voltage-carrying wire (pinched harness) high
- Bridged or corroded connector at the indicator medium
- Leaking or failed output stage in the control module low
Symptoms
- Indicator channel A lights constantly or glows faintly
- Port shows a misleading charging status
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D88
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.