P0D80
Battery Charger Input Circuit/Open
P0D80 means the on-board charger sees no usable AC supply at its input even though the charging handshake says power should be there. Ford documents the check for its plug-in hybrids in the OBD summaries for model years 2014 to 2018: with the cable connected, the EVSE active and the S2 switch closed, an input below 85 VAC lasting 30 seconds sets the code, and Ford's code dictionary marks it as a MIL code. The fault can therefore lie outside the car, for example a dead EVSE or a tripped breaker, as well as in the charge inlet, the AC harness or the charger itself. P0D81 to P0D84 cover implausible or electrically wrong input signals, P0D27 a supply that is present but too low. The driver notices that the car does not charge.
Possible causes
- Charging station or outlet delivers no AC after the handshake (fault, tripped breaker) high
- Open AC contact or wire between charge inlet and charger medium
- Fault in the charger's input stage or voltage measurement low
Symptoms
- Vehicle does not charge although the cable is plugged in
- Charging fault message or flashing fault pattern at the charge port
- Check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D80
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.