P0D78
A/C Compressor Control Module Output Driver Temperature Sensor Circuit Low
P0D78 is set when the output driver (IGBT) temperature sensor of the electric A/C compressor signals low, which for an NTC sensor means an implausibly hot value. GM uses 274 °C or more in the 2011–2015 Volt and the 2016 ELR, and above 150 °C in the 2016–2019 Volt; detection takes 30 of 60 samples at 50 ms, 40 of 50 at 100 ms or 4 of 5 s, Type B with MIL after two trips. Temperatures like these are beyond what the power stage survives, so a shorted sensor is more likely than real heat, although a seized compressor or a failed condenser fan can drive the IGBTs hot. Expect the A/C to switch off. The cold-side counterpart is P0D77, plausibility P0D76.
Possible causes
- Short circuit in the IGBT temperature sensor path high
- Real overheating of the power stage from high load or poor condenser cooling low
- Faulty value transmission to the host controller low
Symptoms
- Check engine light after two trips
- Air conditioning switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D78
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.