OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D77

A/C Compressor Control Module Output Driver Temperature Sensor Circuit High

P0D77 is the high-signal circuit code of the output driver (IGBT) temperature sensor in the electric A/C compressor. As with an NTC sensor, the high signal shows up as an impossibly cold temperature: GM sets it when the IGBT reading is at or below −40 °C, in all Volt and ELR tables from 2011 to 2019. The first-generation Volt needs 30 of 60 samples at 50 ms and evaluates only with outside air above −7 °C; the 2016 Volt counts 40 of 50 samples at 100 ms, the 2019 Volt 4 of 5 s, with the compressor reporting the fault over GMLAN. Type B, MIL after two trips. Without a valid power-stage temperature the compressor cannot protect itself and is normally switched off. Likely an open sensor path on the inverter board; hot-side code P0D78.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 77

Possible causes

  • Open circuit in the IGBT temperature sensor path high
  • Cracked solder joint on the inverter board medium
  • Faulty value transmission to the host controller low

Symptoms

  • Check engine light after two trips
  • Air conditioning switched off

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0D77

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication