OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D76

A/C Compressor Control Module Output Driver Temperature Sensor Performance

P0D76 checks whether the compressor's output driver (IGBT) temperature sensor agrees with other temperatures after a cold soak. GM's 2011 Volt fails it when the IGBT reading differs from outside air by more than 11 °C and from the CPU sensor by more than 7 °C after the compressor has been off for over 21,600 s, with coolant and outside air within 15 °C of each other; 35 of 40 samples at 250 ms. The 2016 Volt uses 22 °C for both comparisons after 7,200 s off, the 2016 ELR 15 °C, and the 2019 Volt 22 °C in 8 of 10 s, where every comparison must fail together. Each is Type B, MIL after two trips. Causes: drifting sensor, wrong reference value, residual heat. Range codes are P0D77 and P0D78.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 76

Possible causes

  • Drifting IGBT temperature sensor in the compressor inverter high
  • Outside air or CPU temperature used for comparison is wrong medium
  • Power stage still warm when the test ran low

Symptoms

  • Check engine light after two trips
  • Usually no noticeable change in A/C operation

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0D76

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication