OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D75

A/C Compressor Control Module Output Driver Temperature Sensor Circuit

The output driver temperature sensor watches the power transistors (IGBTs) that switch the three motor phases of an electric A/C compressor; they heat up under load, and the compressor reduces speed or stops before they overheat. P0D75 is the general circuit code for this sensor without a defined low or high value. No manufacturer documents P0D75 publicly; GM's Volt and ELR use P0D76 to P0D78 for the same sensor and mention P0D79 in enable conditions. A Denso patent on hybrid compressor control describes throttling the compressor when the IGBT module runs hot, which is why losing this signal normally halts it. CARB requires such thermal-management inputs to be monitored. The sensor is built into the inverter, so repair usually means a new compressor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 75

Possible causes

  • Temperature sensor at the IGBT module or its circuit failed high
  • Sensor value not transmitted correctly to the vehicle medium
  • Unstable 12 V supply or ground of the compressor electronics low

Symptoms

  • Air conditioning switched off
  • Battery cooling via refrigerant may be limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0D75

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication