P0D73
A/C Compressor Control Module Internal Temperature Sensor A Circuit Low
P0D73 is the low-signal circuit code for the internal (CPU) temperature sensor of the compressor control module. For an NTC sensor a low signal corresponds to an implausibly hot reading. GM sets it above 274 °C in the 2011–2015 Volt and 2016 ELR, and above 150 °C in the 2016–2019 Volt, where the compressor itself detects the condition and reports it over GMLAN; counting is 30 of 60 samples at 50 ms, 40 of 50 at 100 ms or 4 of 5 s depending on the year, Type B. Values like these suggest a shorted sensor rather than real heat, although genuine overheating of the electronics should be ruled out by checking. The compressor may limit or stop operation. The cold-side code is P0D72, plausibility P0D71.
Possible causes
- Short circuit in the internal temperature sensor path high
- Real overheating of the compressor electronics low
- Faulty value transmission to the host controller low
Symptoms
- Check engine light after two trips
- Air conditioning reduced or switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D73
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.