OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D72

A/C Compressor Control Module Internal Temperature Sensor A Circuit High

P0D72 is the high-signal circuit code for the compressor module's internal temperature sensor. With the usual NTC thermistor a high signal means the reading looks extremely cold, and that is how GM defines it: every Volt and ELR table from 2011 to 2019 sets it when the reported CPU temperature is below −40 °C. Timing is 30 of 60 samples at 50 ms in the first-generation Volt, 40 of 50 at 100 ms in 2016 and 4 of 5 s in 2019, each Type B with MIL after two trips; the older tables only check with outside air above −7 °C. In the J2012 list this High code comes before the Low code P0D73. Typical cause is an open sensor path or a cracked solder joint on the compressor board, so the assembly is usually replaced.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 72

Possible causes

  • Open circuit in the internal temperature sensor path high
  • Cracked solder joint on the compressor electronics board medium
  • Faulty value transmission to the host controller low

Symptoms

  • Check engine light after two trips
  • Air conditioning limited or switched off

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0D72

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication