P0D68
A/C Compressor Motor Voltage Sensor A Circuit
An electric A/C compressor in a hybrid or EV runs its motor from the high-voltage battery through an inverter in the compressor housing, and a sensor there measures the incoming high voltage. P0D68 is the general circuit code for that sensor: its signal is missing or unusable as a whole, without a specific low or high reading. No manufacturer documents P0D68 publicly. GM (Volt) and Mitsubishi (Outlander PHEV) monitor the same sensor but use P0D69 for plausibility against the battery voltage and P0D6A/P0D6B for out-of-range values. CARB requires electronic A/C components to be monitored where they affect engine control or other diagnostics. In practice the compressor controller stops the compressor when it cannot trust its input voltage, so cabin cooling and any refrigerant-based battery cooling are lost.
Possible causes
- Voltage measurement inside the electric compressor's inverter failed high
- Compressor reports its sensor value over a faulty data link medium
- Poor high-voltage connection at the compressor low
Symptoms
- Air conditioning does not cool
- Warning message or warning light, depending on the vehicle
- Battery cooling via refrigerant may be limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D68
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.