P0D67
Battery Charger Control Module A Performance
P0D67 says that the control electronics of the on-board charger are not working properly. Mitsubishi's Outlander PHEV manuals (2019 and 2022) spell out what that means there: with the charger supplied at 10 to 16 V, the code sets when one of its internal supply rails leaves its window for 1 s, 3.0 to 3.6 V for the 3.3 V rail, 5.3 to 6.8 V for the 6 V rail or 9.4 to 14.9 V for the 12 V rail. Charging is then stopped, and the only listed remedy is a new charger/DC-DC converter unit. Kia's bulletin 298 for the 2023 Niro EV names P0D67 among codes that lead to replacing the integrated charging control unit (ICCU) and mentions a possible MIL. Driving usually still works, but plug-in charging does not. Processor faults of the same module are P0E5E.
Possible causes
- Internal low-voltage supply of the on-board charger out of tolerance high
- On-board charger or integrated charging unit failed high
- Weak 12 V supply or poor ground at the charger low
- Charger software fault, fixed by an update where available low
Symptoms
- Plug-in charging stops or does not start
- Electric vehicle system warning in the cluster, possibly MIL
- Vehicle can still be driven on stored energy or fuel
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D67
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.