OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D64

Hybrid/EV Battery Pack Cooling Fan Enable Circuit/Open

Besides its speed command, a battery cooling fan can have a separate enable line that switches the fan electronics on. P0D64 means the controller has found this enable output open. GM documents it in its hybrid OBD tables 16OBDG02 to 19OBDG02 under the battery system module, there named fan 1 enable: with the enable commanded off and system voltage above 10.2 V, an output voltage stuck between 1.14 and 2.81 V counts as an open circuit, and 16 failures in 20 samples at 250 ms set it as Type B, MIL after two trips. The fan speed diagnostic P0BC8 is suspended while P0D64 to P0D66 are active. Typical causes are a broken wire or an unplugged fan connector. Without enable the fan stays off, so the battery heats faster and power may be reduced. Short to ground is P0D65, short to voltage P0D66.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 64

Possible causes

  • Broken enable wire between battery controller and fan high
  • Fan connector unplugged or not latched, often after battery or trim work medium
  • Open enable input inside the fan electronics medium
  • Enable driver in the battery system module defective low

Symptoms

  • Check engine light or hybrid warning after two trips
  • Battery cooling fan does not run
  • Reduced electric assist when the battery gets hot

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0D64

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication