OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D58

Proximity Detection Circuit A Low

P0D58 reports a voltage on proximity circuit A that is too low while no plug can possibly be inserted. GM's Volt checks this in its hybrid control processor: in 2011 with the charge door closed or above 12.4 mph in a range other than Park, from 2016 above 20 km/h outside Park, the signal must sit in a window, and less than 4.2 V for 30 of 50 samples (later 240 of 400) sets the code as a Type A fault with immediate MIL. In the third-generation smart electric drive with 22 kW charger, Mercedes defines P0D5800 as a short to ground of this contact sensing; bulletin LI54.10-P-067823 links it to loose low-voltage plugs at the charger, a car that will not start and a cable-plugged-in message. The high counterpart is P0D59.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 58

Possible causes

  • Proximity signal wire shorted to ground or chafed against body high
  • Loose low-voltage connector at the on-board charger (smart) medium
  • Moisture or contamination bridging the inlet contacts medium
  • Evaluation input of the control module failed low

Symptoms

  • MIL on (GM)
  • Vehicle will not start or shift because a plug appears connected
  • High-voltage battery cannot be charged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D58

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication