OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D56

Proximity Detection Circuit A

P0D56 is the general circuit fault of proximity detection circuit A, the line through which the vehicle notices that a charging plug sits in its inlet. Under SAE J1772 this proximity pin runs to protective earth through resistors in the plug and a switch tied to the latch button, so the car can block driving away and end charging before the plug is pulled; under IEC 62196 a resistor on the same pin also codes the cable's current rating. This is a different line from the control pilot, which carries the PWM dialogue with the charging station and has its own codes P0CF3-P0CF6. No manufacturer documents P0D56 publicly. A fault can mean no charging, or a car that thinks it is still plugged in.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 56

Possible causes

  • Damaged or corroded proximity contact in the charge inlet high
  • Open or chafed wire between charge inlet and evaluating module medium
  • Evaluation input in the charger or control module failed low

Symptoms

  • Charging does not start although the cable is plugged in
  • Vehicle refuses to drive or shows the cable as connected without a plug
  • Charging system warning

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D56

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication