P0D54
Battery Charger Hybrid/EV Battery Output Current Sensor Circuit High
P0D54 marks a current reading at the charger's high-voltage output that exceeds the sensor's upper limit. The limit sits well above normal charging current, so the value counts as an electrical fault rather than real current. GM's 2011 Volt charger module triggers at 18 A or more, the 2014 Volt/ELR table at 17.7 A, each over 400 of 500 ms and rated Type A with MIL. Mitsubishi's 2022 Outlander PHEV logs it as a short to supply once the sensor voltage exceeds 4.658 V, corresponding to roughly 54 A, for 0.5 s; charging is stopped and the charger/DC-DC unit replaced. While P0D54 is stored, GM suspends its output power plausibility test P0D5C. The low-side fault is P0D53.
Possible causes
- Current sensor output shorted to supply voltage in the charger high
- Charger current measuring stage failed high
- Sensor output stuck at its upper end low
Symptoms
- AC charging interrupted or refused
- MIL on (GM)
- Charge level stays unchanged after plugging in
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D54
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.