P0D48
Battery Charger 14 Volt Output Current Sensor Circuit Range/Performance
P0D48 marks a current reading at the charger's 14 V output that lies within its electrical range but makes no sense in context. No manufacturer documents P0D48. GM covers a related check differently: its Volt and ELR charger module multiplies the 14 V output voltage by the current and sets P0D5B when this low-voltage power exceeds a limit derived from the measured AC input power plus 125 W. Out-of-range current faults are P0D49 and P0D4A, the circuit code is P0D47. CARB defines a rationality diagnostic as comparing a sensor with all other available information, which is exactly what this code represents. Suspects are drift in the charger's sense circuit or its software; repair normally means reprogramming or replacing the charger.
Possible causes
- Current sense circuit inside the charger has drifted medium
- Charger module software or calibration medium
- Failed low-voltage stage of the charger low
Symptoms
- Charging fault indication
- 12 V support during charging reduced or switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D48
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.