P0D47
Battery Charger 14 Volt Output Current Sensor Circuit
P0D47 is the general circuit code for the current sensor in the charger's 14 V output, the measurement of how much current the charger's internal low-voltage stage delivers. No manufacturer publishes this code; GM's Volt and ELR charger module measures the same current but reports only low and high readings (P0D49, P0D4A), with 54 A as its upper limit. Range and sporadic faults have the codes P0D48 and P0D4B. The Ford patent on a DC/DC stage housed in the charger describes such a unit feeding the 12 V bus whenever the car is connected to a charging station. Under CARB rules every input of this kind must be checked for circuit faults. Without a valid current value the charger cannot limit its auxiliary output, so it may switch that stage off.
Possible causes
- Open or shorted current sense circuit of the low-voltage stage medium
- Failed on-board charger electronics medium
- Damaged 12 V output connector at the charger low
Symptoms
- 12 V battery discharges during long charging sessions
- Charging may be interrupted
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D47
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.