P0D43
Battery Charger 14 Volt Output Voltage Sensor Circuit Range/Performance
P0D43 says the voltage reported for the charger's 14 V output does not fit other measurements of the low-voltage system. GM's battery charger control module in the 2011-2014 Volt and the ELR compares the reading with the run/crank signal voltage and with the voltage of a further enable line (HVEMB); a difference of 6 V or more for 4 of 5 s stores a Type A fault with MIL. The test is suspended while the out-of-range codes P0D44/P0D45 or a reference voltage fault are present. In GM's design this output is a low-voltage DC stage inside the charger, separate from the Volt's accessory power module. A failing sense circuit in the charger is most likely, a poor ground or 12 V feed less so; charging can be affected.
Possible causes
- Low-voltage sense circuit inside the charger reads wrong high
- Poor ground or 12 V feed at the charger skews the comparison medium
- Charger module software low
Symptoms
- MIL on (GM)
- Charging interrupted or not completed
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D43
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.