P0D3B
Battery Charger A Input Current Sensor Circuit High
P0D3B reports that the charger A input current sensor reads too high. On the 2022 Outlander PHEV Mitsubishi interprets a sensor voltage above 4.658 V, equivalent to more than about 54 A, lasting 0.5 s as a short to the supply side; charging ends and the integrated charger/DC-DC unit is the listed part. GM's Volt charger module (2011 and 2014 tables) sets the code when the reported AC current exceeds 24.78 A for 160 of 200 ms and lights the MIL as a Type A fault. The low counterpart is P0D3A; a reading that looks valid but carries an offset is P0D39. Since the grid cannot push that much current through the charger unnoticed, the sensor path is the first suspect. Owners see AC charging refuse to start or quit shortly after plugging in.
Possible causes
- Current sensor signal shorted to supply voltage inside the charger high
- Failed on-board charger/DC-DC unit medium
- Genuine overcurrent at the charger input from an internal short low
Symptoms
- AC charging quits shortly after plugging in
- MIL on (GM)
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D3B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.