OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D3A

Battery Charger A Input Current Sensor Circuit Low

P0D3A is the low-signal fault of the charger A input current sensor. Mitsubishi defines it for the 2022 Outlander PHEV as a short to ground: if the sensor output falls below 0.344 V, which corresponds to roughly -54 A, for 0.5 s while the charger supply is 10-16 V, charging is stopped and the combined charger and DC/DC unit is swapped. GM's battery charger control module in the 2011 Volt compares the reported current with a lower bound (0.8 A; 1.65 A in the 2014 table with AC voltage above 80 V) for 160 of 200 ms and rates it Type A, so the MIL comes on. The mirror fault is P0D3B, offset errors fall under P0D39. Usually the sensor inside the charger is at fault rather than outside wiring; charging stays unavailable until repaired.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 3A

Possible causes

  • Current sensor signal shorted to ground inside the charger high
  • Failed on-board charger/DC-DC unit medium
  • Unstable 12 V supply to the charger module low

Symptoms

  • AC charging stops or never begins
  • MIL on (GM)

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0D3A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication