P0D39
Battery Charger A Input Current Sensor Circuit Range/Performance
P0D39 flags an implausible reading from the sensor that measures alternating current at the input of charger A, the on-board charger. Both documented users test its zero point. GM's charger module in the 2011 Volt sets the code as a Type A fault with MIL when the current value sits 5.4 A or more away from zero for 512 of 640 ms although no current should flow; the 2016 ELR table uses 1.4 A. Mitsubishi's 2022 Outlander PHEV logs it when 1.5 A or more is seen for 2 s while the PHEV-ECU has not released charging, then stops charging and calls for a new charger/DC-DC unit. Hard electrical faults of the same sensor are P0D3A and P0D3B, the general circuit code is P0D38. The car still drives, but AC charging is blocked.
Possible causes
- Zero point of the current sensor inside the charger has drifted high
- Measuring electronics of the on-board charger failed medium
- Charger calibration out of date low
Symptoms
- AC charging does not start
- MIL on (GM)
- Charging fault shown at the charge port or in the cluster
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D39
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.