P0D2D
Drive Motor A Inverter Voltage Sensor A Circuit
Drive motor A's inverter measures the DC link voltage it switches, and voltage sensor A is the channel that passes this value to the motor controller. P0D2D is the general circuit fault for that channel: the signal is missing or electrically unusable, without a more specific low or high verdict. Ford lists P0D2D among its MIL codes. On 2021 Mustang Mach-E vehicles it could be stored in secondary on-board control module C after charging, when a remote start ended in a no-start; customer satisfaction program 21B02 cured this with new software for the PCM and associated modules. Without a trusted bus voltage the controller usually limits or blocks electric drive. Plausibility faults are P0D2E, low and high signals P0D2F/P0D30, short dropouts P0D31.
Possible causes
- Inverter or powertrain module software fault (Ford 21B02) medium
- Loose connector or damaged signal wiring of the voltage sensor medium
- Voltage sensing circuit inside the inverter failed medium
Symptoms
- Hybrid or EV system warning and MIL
- Vehicle does not become ready to drive or electric drive is reduced
- No start after charging and remote start (Mach-E)
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D2D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.