P0D29
Battery Charger Input Current Too Low
P0D29 is set when the on-board charger draws less AC current than expected for the power it was asked to deliver, while voltage and charging permission are present. No manufacturer documents P0D29 publicly. Related tests show how such a check is built: GM's Volt compares the AC input current with fixed limits for the high side (P0D2A), and Mitsubishi first verifies that the input current sensor reads plausibly before trusting it (P0D39). A low current with normal voltage points to a charger that does not ramp up, high resistance at the inlet or cable, an EVSE that limits current, or a measurement fault. CARB requires charger faults that limit the charging rate to be detected. Charging is slower than usual or stops. Too much current is P0D2A, voltage problems P0D27/P0D28.
Possible causes
- Charger power stage not ramping up medium
- High resistance at the charge inlet, cable or plug contacts medium
- Input current sensor reading too low low
- Charging station or cable limiting current more than signalled low
Symptoms
- AC charging much slower than usual
- Charging stops or charging system warning
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D29
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.