P0D28
Battery Charger Input Voltage Too High
P0D28 is the mirror case of P0D27: the AC voltage at the charger input lies above the range the charger can accept. Mitsubishi evaluates both on the Outlander PHEV while the PHEV-ECU allows charging; the charger then stops and the technician works from the outside in, beginning with the supply and the charging cable, then the wiring between inlet and charger, and only last the charger. A real overvoltage is rare on public grids, so a faulty voltage measurement or software is often more likely. Audi lists P0D2800, battery charger primary voltage too high, among ghost DTCs stored by software 0088 in the high-voltage charger module of the e-tron and Q8 e-tron (2021-2024); bulletin 2062631 says to leave them unrepaired unless a charging complaint exists. Sensor faults are P0D3E-P0D40.
Possible causes
- Input voltage sensing inside the charger reading too high medium
- Charger software storing the code without a real fault (Audi ghost DTC) medium
- Actual overvoltage or unstable supply at the charging location low
- Faulty charging cable or EVSE low
Symptoms
- AC charging stops or does not start
- Code found in memory without any complaint
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D28
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.