P0D27
Battery Charger Input Voltage Too Low
P0D27 says the AC voltage reaching the on-board charger sits lower than the charger accepts while charging is permitted. Unlike most charger codes, the cause often lies outside the car. Mitsubishi's Outlander PHEV stops charging and tells technicians to check, in order, the customer's power supply, the charging cable, the high-voltage wiring between charge inlet and charger and finally the charger itself. Stellantis lists P0D27-00 as Battery Charger 1 Input Voltage Too Low in the integrated dual charging module of the 2021 Jeep Wrangler 4xe, with MIL, no level 2 charging and in some cases a tripping house breaker; the remedy is new IDCM software along with several other modules. Later notes ask for a test charge after clearing before an IDCM is replaced. Too high an input voltage is P0D28.
Possible causes
- Weak or overloaded AC supply at the charging location high
- Faulty charging cable or EVSE medium
- Charger module software (Stellantis IDCM reflash) medium
- Damaged wiring or loose contact between charge inlet and charger low
Symptoms
- AC charging does not start or stops
- House circuit breaker trips when plugging in
- MIL
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D27
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.