P0D21
Battery Charger A Output Voltage Too Low
P0D21 is set when the high-voltage output of the on-board charger stays below what the controller expects. GM's Volt and ELR tables split the test in two: during normal charging the charger bus must not fall under 150 V, and when the charger only powers the battery heater, the bus must reach at least 75 % of an expected value calculated from charger current times 70 ohms. Eight failures in ten samples store it as Type B, lighting the MIL on the second trip. Stellantis stores P0D21-00 in the integrated dual charging module (IDCM) of the Jeep Wrangler 4xe from 2021, the Grand Cherokee 4xe from 2022 and the Pacifica Plug-in Hybrid from 2022, with MIL and no charging, and reflashes the IDCM. P0D20 covers a deviation in constant-voltage mode, P0D85 excess voltage.
Possible causes
- Charger module software (Stellantis IDCM bulletins) high
- Failing power stage inside the charger medium
- High resistance or fault in the charger's high-voltage output path or heater load low
Symptoms
- Vehicle does not charge
- MIL, often after two charging trips
- Battery not preheated while plugged in during cold weather
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D21
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.