P0D20
Battery Charger A Output Voltage Performance
P0D20 concerns the on-board charger in its constant-voltage phase, typically near the end of a charge, when it should hold its high-voltage output at a set value. The code means the measured output voltage strays too far from that target. GM's 2011 to 2013 Chevrolet Volt evaluates this in the HPC2/VICM: a deviation of 15 % or more in constant-voltage mode, counted at 100 ms with system voltage above 9 V (2011) or 10.2 V (2012), sets the code after 30 failures in 50 samples, One Trip Type A, so the MIL comes on at once. Later GM tables no longer list it. CARB requires charger faults that stop or slow charging to be detected. Causes lie mostly inside the charger or its voltage sensing. Charging stops or ends early; driving is unaffected. Too low a voltage is P0D21.
Possible causes
- Fault in the charger's power stage or voltage control high
- Inaccurate output voltage measurement medium
- Charge control software in the hybrid control module low
Symptoms
- Charging stops early or the battery does not reach its target level
- MIL and charging system message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D20
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.