P0D1F
Control Module Date/Time Synchronization Error
P0D1F says a control module could not align its internal date and time with the reference the rest of the vehicle uses. Hybrid modules need a trustworthy clock because several checks depend on how long the car has been parked: CARB, for example, ties cold-start monitoring to at least six hours off, and GM separately checks its module power-off timer against the on-timer (P262B, more than 5.6 % deviation on the 2012 Volt). Volvo stores P0D1F62 in the BECM of its long-range plug-in hybrids from 2022 to 2024 with the check engine light on. Journals TJ 36681 and TJ 36707 call it a misdetection, rule out parts replacement and prescribe BECM software 2.11. If P0D1F96 follows the update, the car must sleep at least 15 minutes to resync its timers before the code is erased.
Possible causes
- Module software misdetecting the time comparison (Volvo BECM software 2.11) high
- Timers not yet resynchronised after programming because the car has not slept medium
- Missing or wrong time information from the module providing the reference clock low
Symptoms
- Check engine light without a noticeable driving fault
- Code returns as a variant after a software update until the car has slept
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D1F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.